User's Manual

1. Introduction

In this section, we will focus on how to do RF test AT command inside MC300.

Users can use AT command through UART.

2. Hardware connection

Note

：According to the pictures of by method of jump line

3. RF test AT Command list

3.1 ICAT+RADIO_CHANNEL=n

set channel

n =[1~14]

3.2 ICAT+RADIO_RF_START

Enter RF TX Test Mode

3.3 ICAT+RADIO_RF_STOP

Stop RF TX Test Mode

3.4 ICAT+RADIO_RF_RATE=n

set TX rate format

N=0 ~ 38