User's Manual

HF-LPB125 Low Power Wi-Fi Module User Manual

Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com) -

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator &

your body.

FCC INFORMATION (additional)

OEM INTEGRATION INSTRUCTIONS:

This device is intended only for OEM integrators under the following conditions: The module must

be installed in the host equipment such that 20 cm is maintained between the antenna and users,

and the transmitter module may not be co-located with any other transmitter or antenna. The

module shall be only used with the internal antenna(s) that has been originally tested and

certified with this module. As long as 3 conditions above are met, further transmitter test will not

be required. However, the OEM integrator is still responsible for testing their end-product for any

additional compliance requirements required with this module installed (for example, digital

device emissions, PC peripheral requirements, etc.).

Validity of using the module certification:

In the event that these conditions cannot be met (for example certain laptop configurations or co-

location with another transmitter), then the FCC authorization for this module in combination with

the host equipment is no longer considered valid and the FCC ID of the module cannot be used

on the final product. In these circumstances, the OEM integrator will be responsible for re-

evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.