User Manual

High-Flying
HF-LPT200 Low Power WiFi Module User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com) - 46 -
+ok=<ipaddress,mask><CR><LF><CR><LF>
 Set Operation
AT+LANN=< ipaddress,mask><CR>
+ok<CR><LF><CR><LF>
 Parameters:
 ipaddress: AP’s IP address;
 mask: AP’s net mask;
4.2.2.45. AT+WAP
 Function: Set/Query AP Wi-Fi parameters. Setting is valid after reset.
 Format:
 Query Operation
AT+WAP<CR>
+ok=<wifi_mode,ssid,channel><CR><LF><CR><LF>
 Set Operation
AT+WAP =<wifi_mode,ssid,channel><CR>
+ok<CR><LF><CR><LF>
 Parameters:
 wifi_mode: Wi-Fi mode, include:
 11B
 11BG
 11BGN (Default Value)
 ssid:SSID at AP mode
 channel: Wi-Fi channel selection:
 AUTO
 CH1~CH11; (Default CH1)
4.2.2.46. AT+WAKEY
 Function: Set/Query AP Wi-Fi secruity parameters. Setting is valid after reset.
 Format:
 Query Operation
AT+WAKEY<CR>
+ok=<auth,encry,key><CR><LF><CR><LF>
 Set Operation
AT+WAKEY=< auth,encry,key><CR>
+ok<CR><LF><CR><LF>
 Parameters:
 auth: include
 OPEN
 WPA2PSK
 Encry: include
 NONE: When “auth=OPEN” available;
 AES: When “auth=WPA2PSK” available;
 key: security code, ASCII code, smaller than 64bit and bigger than 8 bit;