User Manual

High-Flying
HF-LPT200 Low Power WiFi Module User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com) - 52 -
AT+RLDEN=<status><CR>
+ok<CR><LF><CR><LF>
 Parameters:
 status: The status of module’s nReload pin function
 on: nReload pin function is enabled.
 off: nReload pin function is disabled
4.2.2.65. AT+ASWD
 Function: Set/Query WiFi Configuration Password;
 Format:
 Query Operation
AT+ASWD<CR>
+ok=<aswd> <CR><LF><CR><LF>
 Set Operation
AT+ASWD=<aswd> <CR><LF><CR><LF>
 Parameters:
 aswd: WiFi Configuration Password (within 20 characters).
4.2.2.66. AT+MDCH
 Function: Set Wi-Fi Auto Switch Function. Setting is valid after reset.
 Format:
 Query Operation
AT+MDCH<CR>
+ok=<mode> <CR><LF><CR><LF>
 Set Operation
AT+MDCH=<mode> <CR><LF><CR><LF>
 Parameters:
 mode: Wi-Fi Auto Switch Mode
 off: Disable Wi-Fi auto switch.
 on: Enable Wi-Fi auto switch. When the module(STA mode) fail to connect to
router, it will switch to AP mode itself in one minute.
 auto: Enable Wi-Fi auto detect function. The module will reset itself when
encounter any abnormal. The default time interval is 10 minutes. (default
mode)
 3-120: unit: minute. Set the time interval to reset itself when abnormal.
4.2.2.67. AT+TXPWR
 Function: Set/Query Wi-Fi Transmit Power, Real Transmit Power=Default Transmit
Power(16dBm) – [Setting Value] * 0.5dBm. Setting is valid after reset.
 Format:
 Query Operation
AT+TXPWR <CR>
+ok=<num><CR><LF><CR><LF>
 Set Operation