User guide

Q219.001

2005~2011 Kawasaki

650 Brute Force

Stage 1

For mildly tuned machines using the stock airbox with

stock or aftermarket filter. May also be used with a

good aftermarket exhaust system.

Parts List

1 Main Jet DJ120

1 Main Jet DJ124

1 Main Jet DJ128

1 Main Jet DJ132

1 Main Jet DJ136

1 Main Jet DJ140

1 Main Jet DJ144

2 Fuel Needles DNO304

4 Adjusting Washers DW0001

2 E-Clips DE0001

2 Slide Springs DSP031

1 Plug Drill DD 5/32

1 Screw DS0001

PAGE 1
Q219.001 2005~2011 Kawasaki 650 Brute Force Stage 1 For mildly tuned machines using the stock airbox with stock or aftermarket filter. May also be used with a good aftermarket exhaust system.
PAGE 2
Q219.001 STAGE ONE INSTRUCTIONS 1.Remove vacuum slides from carbs. Remove stock needles & spacers, noting order of assembly (Fig.A). 2. Install Dynojet needles on groove #5 for applications below 5000 feet, groove #4 for above 5000 feet, using all stock spacers. Install the Dynojet washers above the E-clip, 2 per needle (Fig.A). 3. Install the Dynojet slide spring (DSP031) in place of the stock slide springs. This is Groove # 1 4. Remove stock main jets and replace with Dynojet main jets provided.