Manual

Q403.001

1996-2005 Yamaha

350 Wolverine

Stage 1

For mildly tuned machines using the stock airbox with

stock or aftermarket filter. May also be used with a

good aftermarket exhaust system.

Parts List

1 Main Jet DJ144

1 Main Jet DJ150

1 Main Jet DJ155

1 Main Jet DJ160

1 Fuel Needle DNO360

1 Slide Drill DD 32

1 Adjusting Washer DW0001

1 E-Clip DE0001

PAGE 1
Q403.001 1996-2005 Yamaha 350 Wolverine Stage 1 For mildly tuned machines using the stock airbox with stock or aftermarket filter. May also be used with a good aftermarket exhaust system.
PAGE 2
Q403.001 STAGE ONE INSTRUCTIONS 1. Remove vacuum slide from the carb. Remove stock needle & spacers, noting order of assembly. 2. Locate the slide lift hole (Fig. A). Use the (DD32) drill provided to enlarge slide lift hole (Fig. A). 3. Install Dynojet needle on groove #4 for applications below 5000 feet, groove #3 for above 5000 feet, using all stock spacers. Install the Dynojet washer above the E-clip. This is Groove # 1 4. Remove the stock main jet and replace withthe Dynojet main jet provided.