NOTES:
High Lifter Products, Inc. 780 N Professional Drive Shreveport, LA 71105 Ph# 318-542-2270 Fax 318-524-2297 Honda 350 Rancher Lift Kit Installation Instructions READ BEFORE INSTALLATION! This product is designed for use on ATVs on which additional ground clearance and fender clearance is desired. It is designed for utility type, slower-speed use on relatively flat terrain in deep mud or snow.
Parts List Brackets “A” Qty- 2 “B” Qty- 1 “C” Qty- 1 Top (Larger Notch) “D” Qty- 1 “E” Qty- 2 Spacers “F” Qty- 2 “G”: Qty-2 “H”: Qty-1
Rear Mounting Picture (Left Angle) Rear Mounting Picture (Right Angle)
Front Installation (Rear View)
Front Installation (Front View) This lift kit contains the following parts: Lift Kit Brackets Lift Kit (Spacers) 10mm x 55mm Bolt 10mm Nut 10mm Washer 10mm x 80mm Bolt 10mm Nut x 1.25 pitch 6mm x 16mm Flange Bolt 7 5 4 4 8 2 2 2 Front Lift 1) Chock rear wheels and set parking brake. 2) Loosen front wheel lug nuts. 3) Place jack under center of ATV front-end and lift until front wheels clear the ground.
NOTE: The front brackets can also be installed with the large notch to the inside and the bracket standing essentially in a diagonal angle on the same line as the shock. The reason for this 2nd alternative is that some wheels or tires may touch the bracket if it is installed, standing straight up. Either one is fine. The diagonal installation gives a little more lift but puts a little more downward load on the CV joints.
Front Mounting Diagram FRONT INSTALLATION DIAGRAM (REAR VIEW) “A” (SIDE VIEW) Front Rear Spacer “G” “E” “E” “A” Spacer “F” Rear Mounting Diagram REAR INSTALLATION DIAGRAM (REAR VIEW) OEM SHOCK “B” “C” “D” Spacer “H” 4-Washers AXLE