Owner manual

9
3. Using the name plate as a guide, place it on the location shown in the photo. Center it and mark the ¼” bolt hole
locations.
4. Once you have market the ¼” holes, use a 1/” drill bit and drill the holes.
5. Place the name plate back on the tail gate and insert the ¼ x ¾ button head bolts through the plate and plastic. On the
backside of the tail gate where the bolts are showing, place the ¼” flat washers on the bolts and connect them using the
¼” lock nuts.
6. Reconnect the tail gate.