Manual

ARCTIC CAT PROWLER XT21000

Removal:

You will need to remove the following items to install your new Looney Tuned

Exhaust System. Remove both seats, the center console, stock muffler, stock front and

rear headers, and the heat shield that surrounded the stock 2into1 piece

Install:

First, using the stock header bolts and stock exhaust gasket loosely install the LTE rear

header to the rear cylinder of the UTV; do not tighten the bolts yet. Repeat this step

with the front header on the front cylinder. Next install the rear midpipe to the rear

header and install the spring between the two pipes. Again repeat this step with the

front midpipe and front header. Next install the steel spacers into the stock muffler

mounting grommets as shown.

Install the supplied offset brackets as shown using the longer supplied button head bolts

Next install the mufflers to the midpipes and then the offset brackets. Tighten the all

four bolts on the offset brackets and install the remaining two springs between the

PAGE 1
ARCTIC CAT PROWLER XT21000 Removal: You will need to remove the following items to install your new Looney Tuned Exhaust System. Remove both seats, the center console, stock muffler, stock front and rear headers, and the heat shield that surrounded the stock 2into1 piece Install: First, using the stock header bolts and stock exhaust gasket loosely install the LTE rear header to the rear cylinder of the UTV; do not tighten the bolts yet. Repeat this step with the front header on the front cylinder.
PAGE 2
mufflers and midpipes. Finally tighten all four head pipe bolts. NOTE Make sure the first time the UTV is started it is in a well ventilated area or outside, the header wrap will smoke quite a bit until the sealant is burned off. FIRST RIDE: Before taking your KTM for the first ride make sure NO WIRES ARE TOUCHING THE EXHAUST. Your first ride with your KTM after installing your new exhaust system should only be 15-20 minutes. Then let your system cool and re-tighten all the bolts and clamps.