Owner's manual

YAMAHA Grizzly 700 INSTALLATION INSTRUCTIONS

PLEASE READ INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION

Hardware kit

2 Complete Silencers

1 Left 2 pc exhaust pipe

1 Right 2 pc exhaust pipe

1 8x20 bolt

2 8mm flat washers

2 8mm lock washers

1 silencer mounting assembly

1 heat shield

2 heat shield mounting hardware

1 install instructions

REMOVAL:

Remove seat. Remove left side panel by removing 2 push pins, one by the gas tank under the seat,

and one by the instrument panel. Remove one 6mm bolt in the front fender well. Remove the rear rack, 4

8mm bolts. Remove the rear fender assembly, remove the hardware connecting it to the foot wells, 2

/6mm bolts under the seat, and 2/ 6mm bolts all the way to the rear of the plastic. Remove the stock

exhaust, the silencer first and then the head pipe.

INSTALL:

Install the right head pipe into the right port when sitting on the atv (loose), install the left head

pipe over the right one (loose). Install the mid pipes onto the head pipes from the rear of the atv. Secure

the mid pipes together with the supplied ¼-20 x ½” button head allen ( do not tighten). Slide the silencers

onto the mid pipes from the rear and secure to the stock frame mount with the supplied 8x20mm bolt, flat

washer, and lock washer (do not tighten). For the rear mount use the supplied hardware as seen in picture

# 1 . Start from the header flanges and tighten all hardware back to the silencers. Tighten to

manufacturers specs. Install the supplied heat shield with the clamp and standoff hardware to the mid

pipes as shown in picture # 2 .

F1 note: Torque spec for header flanges 10ft pounds. Improper tighten of header flanges will not

be covered under WARRANTY.

JETTING: The EFI fuel controller provided is for a stock motor with a Looney Tuned Exhaust

System at sea level. Other performance modifications to your bike usually requires changes in fuel.

Final jetting is the customer’s responsibility.

PAGE 1
YAMAHA Grizzly 700 INSTALLATION INSTRUCTIONS PLEASE READ INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION Hardware kit 2 Complete Silencers 1 Left 2 pc exhaust pipe 1 Right 2 pc exhaust pipe 1 8x20 bolt 2 8mm flat washers 2 8mm lock washers 1 silencer mounting assembly 1 heat shield 2 heat shield mounting hardware 1 install instructions REMOVAL: Remove seat. Remove left side panel by removing 2 push pins, one by the gas tank under the seat, and one by the instrument panel.
PAGE 2
W WA AR RN NIIN NG G!! LOONEY TUNED EXHAUST DOES NOT TAKE RESPONSIBILITY FOR DAMAGE THAT MAY OCCUR DURING OPERATION OF YOUR VEHICLE UNDER IMPROPER JET SETTINGS. IT IS THE FINAL RESPONSIBILITY OF THE OWNER/RIDER TO ADJUST JETTING TO SPECIFIC RIDING CONDITIONS AND ELEVATION BEFORE RIDING. QUIET CORES: Quiet cores are an option with this kit. To install the quiet cores remove the rear end caps (turn downs) and install the quiet cores with the tubes facing inward. Re-install the end caps.
PAGE 3
picture #2
PAGE 4
Recommended 2/ 2.00 holes in the air box lid for best performance.
PAGE 5
IMPORTANT MESSAGE—PLEASE READ AND UNDERSTAND! WARRANTY LIMITATIONS Looney Tuned Exhaust (LTE) warrants only to the original purchaser the equipment purchased is free form defects in material and workmanship under normal use and service. Components of the equipment are supplied to LTE by others and LTE warrants such components to the purchaser only to the extent that such components are warranted to LTE by the supplier.