Technical Data

High Performance Cement by Quikrete
®
www.highperformancecement.com • [phone]
FastSet
™
All-Crete
™
FastSet
™
All-Crete
™
Product Description
High Performance Cement FastSet
™
All-Crete
™
is a high early strength
commercial grade grout, requiring only the addition of water.
Product Use
FastSet
™
All-Crete
™
is a dual-purpose product. As a non-metallic fluid
grout meeting ASTM C1107, it is used for anchoring and grouting of
anchor bolts, retrofitted reinforcing steel, steel column bases, bearing
plates, precast concrete key ways and other installations that require
high early and high ultimate strength. Non-shrink characteristics make
it stable and capable of handling load transfers. As a repair material,
the product meets ASTM C928 R3 and is used to make partial depth or
full depth repairs to roads, bridges, industrial floors and other concrete
surfaces.
Size
55 lb (25 kg) bags and 20 lb (9 kg) pails
Yield
Yield will vary with water content. When used as a fluid grout, a 55 lb (25 kg) bag will yield approximately 0.53 cu
ft (15 L). Yield will be reduced to approximately 0.50 cu ft (14.2 L) per bag at a flowable consistency. As a repair
material placed at a 3” - 6” (76-152 mm) slump, a 55 lb (25 kg) bag will yield approximately 0.48 cu ft (13.6 L).
When extended with 25 lb (11.3 kg) of high quality -1/2” (-12 mm) gravel, a 55 lb (25 kg) bag will yield
approximately 0.62 cu ft (17.6 L).
Technical Data
APPLICABLE STANDARDS
ASTM International
• ASTM C109/C109M Standard Test Method for
Compressive Strength of Hydraulic Cement
Mortars (Using 2-in. or [50-mm] Cube Specimens)
• ASTM C143/C143M Standard Test Method for
Slump of Hydraulic Cement Concrete
• ASTM C191 Standard Test Methods for Time of
Setting of Hydraulic Cement by Vicat Needle
• ASTM C672/C672M Standard Test Method for
Scaling Resistance of Concrete Surfaces Exposed
to Deicing Chemicals
• ASTM C928 Standard Specification for Packaged,
Dry, Rapid-Hardening Cementitious Materials for
Concrete Repairs
• ASTM C939 Standard Test Method for Flow of
Grout for Preplaced- Aggregate Concrete (Flow
Cone Method)
• ASTM C1090 Standard Test Method for Measuring
Changes inHeight of Cylindrical Specimens of
Hydraulic-Cement Grout
• ASTM C1107 Standard Specification for Packaged
Dry, Hydraulic-Cement Grout (Non-shrink)
• ASTM C1437 Standard Test Method for Flow of
Hydraulic Cement Mortar
PHYSICAL/CHEMICAL PROPERTIES
Typical results, obtained with FastSet
™
All-Crete
™
used
as a grout, are shown in Table 1. Product complies
with all the properties of ASTM C1107 when tested at
73 degrees F (23 degrees C) at a fluid consistency.
Typical results obtained with FastSet
™
All-Crete
™
used
as a repair material are shown in Table 2. Product
complies with applicable portions of ASTM C928 R3
when tested at the conditions specified in Table 2.
Division 3
03 01 00 Maintenance of Concrete
03 13 00 Concrete Topping
03 51 00 Concrete Anchoring
Product No. 1585-54 (bag)
Product No. 1585-24 (pail)