User Manual

___________________________________________________________________________________________
14 www.hightechpet.com High Tech Pet Products, Inc.
The opening motor is energized the entire time the door is open. So
if using only a battery to power the door, and you do not have an AC
Power Adaptor plugged into the door, use this feature sparingly to keep
from discharging the battery in just a few hours.
AUTOMATIC SAFETY RETRACT: Your POWER PET PX is intrinsically safe
for all pets and people, including small children. The door panel weighs
less than 2 lbs. and is closed smoothly by gravity (not the motor) and is
too light to cause any physical injury. However, just to be doubly safe
around infants, we’ve included an automatic safety retract feature. This
feature causes the panel to instantly retract if it encounters an obstruc-
tion during closure.
DEFEATING THE AUTOMATIC SAFETY RETRACT: Under unusual
conditions, such as a warped wall mounting, the door sometimes
may close so slowly that the auto-retract feature triggers the door to
re-open unnecessarily. In these cases it may be desirable to defeat
the Automatic Safety Retract feature. Do this by rst pressing the
OFF button to turn off the door controls and all the lights. Leave the
door powered by the wall wart or battery when you do this. Then
while holding down the MANUAL OPEN button, press and release the
OUTSIDE SENSOR button. The OUTSIDE light will blink to indicate the
feature has been disabled.
ENABLING AUTOMATIC SAFETY RETRACT: Similarly you may en-
able the Automatic Safety Retract feature at any time. Do this by rst
pressing the OFF button to turn off the door controls and all the lights.
Leave the door powered by the wall wart or battery when you do this.
Then while holding down the MANUAL OPEN button, press and release
the INSIDE SENSOR button. The INSIDE light will blink to indicate the
feature has been enabled. When shipped from the factory, the auto-
matic safety retract feature is enabled.
After Defeating or Enabling the feature, press the POWER ON button
to resume normal door operation.