User Manual

___________________________________________________________________________________________

High Tech Pet Products, Inc. www.hightechpet.com 15

PET COLLAR OPERATING INSTRUCTIONS

Your POWER PET DOOR comes with a standard model MS-4 or MS-5

ultrasonic transmitter collar. Each collar includes a battery TEST button

which illuminates a red LED when the battery is OK. If the LED fails to

light, battery replacement is necessary.

Note: To energize the MS-4 Collar, pull out and discard the PULL TAB

which is protruding from the side of the collar.

To energize the MS-5 Collar, open the case, as shown in the Battery

Replacement section below, and pull out the PULL TAB. Discard the

PULL TAB and close up the case.

ADJUSTING THE STRAP

1. Fasten the collar around your pet’s neck so that it ts comfortably. In

most cases there will be excess strap length.

2. With a soft pencil or magic marker, mark the amount of strap to be

removed leaving at least one inch past the D-ring buckle.

3. Remove the collar from your pet and cut off the excess strap at the

mark.

4 To avoid fraying carefully heat the cut end with an open ame to

melt and fuse the material.

5. Re-fasten the collar around your pet’s neck so that it hangs loosely

and comfortably.

Your High Tech Pet MS-4 or MS-5 transmitter collar will operate for 3 to

5 months on a single, easily replaceable battery.

Replacement batteries, part number B3V1A, are available from