Caution : You must read this before you proceed Chair Label Picture Description QTY A Backrest 1 B Seat 1 Page 1 OF 6
C Right Armrest / Leg 1 D Left Armrest /Leg 1 E Seat Cushion 1 Description QTY F Bolt(M6*35MM) 11 G Washer 11 H Allen Key 1 Label Picture Before Beginning Assembly: Page 2 OF 6
Overview Backrest(A) Right Armrest / Leg(C) Seat Cushion(E) Left Armrest / Leg(D) Seat(B) This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all the parts onto a clean and soft surface.
Step 2 Place the Right Armrest/Leg(C), as picture above so as to be attached to the Backrest (A) and Seat(B) using Hardware(F, G) with Allen Key(H). Do not fully tighten the bolts. Step 3 Place the Left Armrest/Leg (D) as pictured above and affix to Backrest (A) and Seat(B) using Hardware(F, G) with Allen Key(H) as shown in Picture 4 and Picture 5. Do not fully tighten the bolts.
Step 4 Stand CHAIR rightside up. Check stability and then tighten the bolts. Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, In a sequential manner, gradually tighten each Bolt until all bolts are evenly secured. This methodology will ensure maximum evenness once all Bolts are fully tightened. Step 5 Put the Seat Cushion(E) on the Seat. Your Chair is ready for use. The Chair can only be used on a flat and level surface.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.