Owner Manual

3
IMPORTANT SAFETY INSTRUCTIONS
PUMP
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
CAUTIONS:
The pump has been evaluated for use with water only.
Risk of electric shock.
Do not remove cord and strain relief. Do not connect conduit to pump.
Do not use the pump in water exceeding 86ºF / 30ºC.
Do not use the pump in flammable liquids.
Do not use the pump for industrial purposes.
Do not use the pump in vehicles or on board ships or aircraft or swimming pools.
Do not use the pump in location where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapor or
gas).
Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
Do not lift the pump by its power cord.
Keep the plug dry. Do not expose the plug to water or steam.
Before connecting to the power source, make sure that the pump is assembled and completely submerged in water.
Always disconnect the pump from the power source before performing any maintenance on the pump, lights (if equipped), or fountain.
Do not exceed the voltage shown on the pump.
Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be fully submerged during
operation. Do not add water while operating the product. Always disconnect the pump from the power source before adding water.
WARNINGS:
1. Risk of electric shock. This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a properly grounded, grounding-type receptacle.
2. To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 ft / 1.52 m in any dimension.
3. If equipped with a 3-prong, grounded type plug, do not remove the grounding pin from the plug on the power cord.
CARE AND MAINTENANCE
ASSEMBLY INSTRUCTIONS
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2
. Select a flat, level surface for the fountain location .
3
. Place the fountain bottom onto the ground and ensure that it is level. Position the fountain top over the fountain
b
ase and insert the fountain top into the fountain bottom until the pieces are secured together (Fig1)
4
. Lead the water supply tube out through the hole on the back of the fountain bottom. Insert the water supply tube int
o
t
he pump outlet that on the top of the pump. ( Fig.2)
5
.Place the pump upright into the fountain bottom
6
. Add clean water into the fountain bottom. The required water level should be approximately 1 in. / 25 mm lower tha
n
t
he hole of the fountain bottom . Connect the Insert pump to a GFCI outlet and the product will begin to function as
i
ntended. (Fig. 2)
7
. If the pump runs with low or high water circulation Check and adjust the regulator dial or slide on the front of the
p
ump. Adjust the dial/slide towards (+) to increase water flow or towards (-) to decrease water flow. (Fig. 3)
8
. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing after th
e
i
nitial setup of your fountain.
I
t is highly recommended that this fountain be placed in an area where it cannot be damaged that might cause
d
amaged with the fountain .
9
. Do not leave your fountain running for extended periods of time when no one is present to observe the
p
erformance.
10. Check the area around your fountain on a regular basis to ensure that there is no leakage.