Use and Care Manual

5. Adjust the temperature by turning the gas control until the desired level

is reached.

6. The water flow can be stopped by sliding the Flow Switch to the “off”

position. The burner will turn off and the pump will continue to operate.

7. Press the Power Button to turn off the device.

Note: Water remaining in the heat exchanger while the flow is stopped

may become very hot. When the flow is resumed, check the temperature

output to make sure it is safe to use.

Once the user has finished using the device, slide the Flow Switch to the

“off” position and press the “START” button to stop the flow of water to

the device.

FAUCET SETUP

To run water through the shower hose in a faucet setup, follow the steps

below to align the hose and the steps under Using The Shower to get

water to flow through the hose.

1. Attach the shower head attachment (attachment #3) to the water

outlet (connection point #3).

2. Remove the shower head from the hose by twisting the base of the

shower head counterclockwise.

3. Lay the tube through the faucet mount (attachment #6) and secure it

in place.