User's Manual

Acoustic Leak Detector User Manual
x
● Please notice that the current limit of USB 3.0 PowerShare port may
vary with the PC brand, which is likely to result in incompatibility issue.
Therefore, it’s advised to use regular USB 3.0 or USB 2.0 port if the USB
device fails to be recognized by PC via USB 3.0 PowerShare port.
● Your camera will periodically perform a self-calibration to optimize
image quality and measurement accuracy. In this process, the image
will pause briefly and you will hear a “click” as a shutter moves in front
of the detector. The self-calibration will be more frequent during start
up or in very cold or hot environments. This is a normal part of
operation to ensure optimum performance for your camera.
Calibration Service
● We recommend you send the device back for calibration once a year,
and please contact the local dealer for the information on maintenance
points. For more detailed calibration services, please refer to
https://www.hikmicrotech.com/en/calibrationservices/2.
Using Environment
● Make sure the running environment meets the requirement of the
device. The operating temperature shall be -10 °C to 50 °C (14 °F to
122 °F), and the operating humidity shall be 95% or less.
● This device can only be safely used in the region below 2000 meters
above the sea level.
● Place the device in a dry and well-ventilated environment.
● DO NOT expose the device to high electromagnetic radiation or dusty
environments.
● DO NOT aim the lens at the sun or any other bright light.
● When any laser equipment is in use, make sure that the device lens is
not exposed to the laser beam, or it may burn out.
● DO NOT aim the lens at the sun or any other bright light.
● The device is suitable for indoor and outdoor uses, but do not expose it
in wet conditions.
● The level of protection is IP 54.