User's Manual

Figure 2-1 Remove Baery Base
2. Hold the lock c
atches, and draw the baery base to take out the baery.
3. Insert the baery into the charging base. You can see the charging status via the pilot lamp on
the charging base.
Figure 2-2 Charge Baery
4. When the
baery is fully charged, draw the baery from the charging base.
5. Insert baery into the device.
2.2 Mount Hand Strap
The upper part of the hand strap is aached to the camera by a buckle. There are two buckles on
both sides of the camera. The lower part of the hand strap is threaded through the hole at the
base of the camera.
Steps
1. Insert the upper part of the hand strap into the buckle.
Handheld Thermal Camera G Series User Manual
5