User's Manual

Note
●
If the measur
ement succeeds, the distance is displayed on the screen. If it fails, adjust the
distance and try again.
●
It is recommended to use a tripod to x the camera if keeping it sll is dicult.
6. Use the le/right buons or the focus ring to adjust the focus, and press aer the "TARGET"
is clear (as sho
wn in the following image).
7. Adjust the target's opcal image with navigaon buons unl it overlaps with the thermal
image, and press . The well-overlapped image is shown as follows.
What to do next
Aer the lens is calibrated, you can check the lens informaon at Sengs → De
vice Informaon
and see the lens type (0.5×, 2×, etc.) on the observaon interface.
2.5 Power On/O
Power On
Remove the lens cover, and hold
for over three seconds to turn on the device. You can observe
the t
arget when the interface of the device is stable.
Note
It may take at least 30 s unl the device is ready for using when you power on it.
Power O
When the device is turned on, hold for three seconds to power
o the device.
Handheld Thermal Camera G Series User Manual
10