User's Manual

What to do next
Check your device to see if the task is successfully received.
5.2 Perform Route Inspecon
Aer receiving inspecon tasks from the PC client, you can hold the device and check the inspect
points on the route. Upload the results when the inspecon is nished.
Before You Start
●
Make sure your device has a memory card installed. See Appearance for instrucons.
●
Connect the device to the PC client, and make sure that your device has received inspecon
tasks from the PC client. See the user manual of HIKMICRO Inspector for instrucons.
Steps
1. Enter inspecon mode to start.
Enter the mode by one of the following ways:
-
Tap at the upper right corner of the screen to enter the inspecon route mode.
-
Press to call the menu, and go to Sengs → Device Sengs → Inspecon Route Mode
to enable the funcon.
Note
●
When in the inspecon route mode, the device le are not accessible.
●
When in the inspecon route mode, sengs of the following funcon are temporarily not
chang
eable: Photo Sengs, QR Code.
When in the inspecon route mode, you can see displayed at the upper right corner of the
scr
een. You can tap the icon to exit the mode.
2. Select an inspecon route task.
1)
Tap on live image or press
to call the menu of inspecon route mode.
2)
Select
and then to show currently received
inspecon route tasks.
3) Select a task to start.
3. Select
or press to see the inspect points that need to be checked in this task and go to the
inspect points one by one.
4. Check the temperature of an inspect point and mark the result. Operaons are dierent
according to the check-in type and diagnosis type sengs of each inspect point.
Check-In Type and
Diagnosis T
ype
Operaon
Handheld Thermal Camera G Series User Manual
27