Quick Start Guide

14
timely technical support if
required.
 Please enforce the protection for
the personal information and the
data security as the device may be
confronted with the network
security problems when it is
connected to the Internet. Please
contact us when the device might
exist network security risks.
 Please understand that you have
the responsibility to configure all
the passwords and other security
settings about the device, and keep
your user name and password.
Maintenance
 If the product does not work
properly, please contact your
dealer or the nearest service center.
We shall not assume any
responsibility for problems caused
by unauthorized repair or
maintenance.
 A few device components (e.g.,
electrolytic capacitor) require
regular replacement. The average
lifespan varies, so periodic checking
is recommended. Contact your
dealer for details.
 Wipe the device gently with a clean
cloth and a small quantity of
ethanol, if necessary.
 If the equipment is used in a
manner not specified by the
manufacturer, the protection
provided by the device may be
impaired.
 To reduce the risk of fire, replace
only with the same type and rating
of fuse.
 The serial port of the equipment is
used for debugging only.
 Disconnect the power source
during servicing.
Using Environment
 Make sure the running
environment meets the
requirement of the device. The
operating temperature shall be -
20 °C to 45 °C (-4 °F to 113 °F), and
the operating humidity shall be
95% or less, no condensing.
 DO NOT expose the device to high
electromagnetic radiation or dusty
environments.
 DO NOT aim the lens at the sun or
any other bright light.
 The equipment shall not be
exposed to dripping or splashing
and that no objects filled with
liquids, such as vases, shall be
placed on the equipment.
 No naked flame sources, such as
lighted candles, should be placed
on the equipment.
 Provide a surge suppressor at the
inlet opening of the equipment
under special conditions such as
the mountain top, iron tower, and
forest.
 Burned fingers when handling the
parts with symbol . Wait
one-half hour after switching off
before handling the parts.
Emergency
 If smoke, odor, or noise arises from
the device, immediately turn off
the power, unplug the power cable,
and contact the service center.
Manufacture Address
Room 313, Unit B, Building 2, 399
Danfeng Road, Xixing
Subdistrict,Binjiang District,
Hangzhou, Zhejiang 310052, China
Hangzhou Microimage Software Co.,
Ltd.
COMPLIANCE NOTICE: The thermal
series products might be subject to
export controls in various countries
or regions, including without
limitation, the United States,
European Union, United Kingdom
and/or other member countries of
the Wassenaar Arrangement. Please
consult your professional legal or
compliance expert or local
government authorities for any