Manual

iv
● The input voltage should meet the Limited Power
Source (5 VDC, 2 A) according to the IEC61010-1
standard. Please refer to technical specifications for
detailed information.
● Make sure the plug is properly connected to the power
socket.
● DO NOT connect multiple devices to one power
adapter, to avoid over-heating or fire hazards caused by
overload.
● Use the power adapter provided by a qualified
manufacturer. Refer to the product specification for
detailed power requirements.
Battery
● The built-in battery cannot be dismantled. Please
contact the manufacture for repair if necessary. The
battery may explode if it is replaced by an incorrect
type. Replace with the same or equivalent type only.
Dispose of used batteries in conformance with the
instructions provided by the battery manufacturer.
● For long-term storage of the battery, make sure it is
fully charged every half year to ensure the battery
quality. Otherwise, damage may occur.
● Make sure the plug is properly connected to the power
socket.
● When the device is powered off and the battery is full,
the time settings can be kept for 60 days.
● The standard adapter power supply is 5 V.
● The battery is certified by UL2054.
Maintenance
● If the product does not work properly, please contact
your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance.
● Wipe the device gently with a clean cloth and a small
quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
device may be impaired.
● Your camera will periodically perform a self-calibration
to optimize image quality and measurement accuracy.
In this process the image will pause briefly and you will
hear a “click” as a shutter moves in front of the
detector. The self-calibration will be more frequent
during the startup or in very cold or hot environments.
This is a normal part of operation to ensure optimum
performance for your camera.
Calibration Service
We recommend you send the device back for calibration
once a year, and please contact the local dealer for the
information on maintenance points. For more detailed
calibration services, please visit
https://www.hikmicrotech.com/en/support/calibration-
service.html.
Technical support
https://www.hikmicrotech.com/en/contact-us.html portal
will help you as a HIKMICRO customer to get the most out
of your HIKMICRO products. The portal gives you access
to our support team, software and documentation,
service contacts, etc.
Using Environment
● Make sure the running environment meets the
requirement of the device. The operating temperature
shall be -10 °C to 50 °C (14 °F to 122 °F), and humidity
shall be 95% or less.
● Place the device in a dry and well-ventilated
environment.
● DO NOT expose the device to high electromagnetic