Manualshelf

Installation Guide

ManualsBrandsHIKOB ManualsComputers & AccessoriesWireless Sensor Gateway
12345678910
Page 4
Installation guide
INSTALL_GATEWAY-LITE-V7
2019/04 Edition
1.1 Compliance and conformity
a. Europe
HIKOB SAS declares that the HIKOB GATEWAY LITE product is in accordance with
stipulations of the RED 2014/53/UE, CEM 2014/30/UE and 2014/35/UE directives.
b. USA
Information to user: This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in an installation. If this equipment does cause
harmful interference to radio or television reception which can be determined by turning the
equipment off and on, the user is encouraged to try to correct interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that to which the receiver
is connected.
– Consult the dealer or an experienced radio/TV technician for help.
RF exposure: This device complies with FCC RF radiation exposure limits set forth for general
population. This device must be installed to provide a separation distance of at least 20cm
from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
Professional installation: This device must be professionally installed, according to
KDB 353028 D01, section II.A.2.c.