User manual

User Manual of Network Camera
120
Figure 6-74 Heat Map Configuration
2. Select Heat Map Configuration tab to set the detailed parameters.
3. Check the checkbox of Enable Heat Map to enable the function.
4. Click Draw Area to define the area for heat value statistics. Draw area by left
click four end-points in the live view window, and right click to finish the area
drawing. Up to 8 areas are configurable.
Note: You can click Select All to select the whole live view window as the
configured area. Or click Delete to delete the current drawn area.
5. Configure the parameters for drawn area.
Detection Sensitivity [0~100]: It refers to the sensitivity of the camera
identify a target. The over-high sensitivity may cause the misinformation. It is
recommended you set the sensitivity as the default value, which is 50.
Background Update Rate [0~100]: It refers to the speed of the new scene
replaces the previous scene. E.g.: In front of a cabinet, the people besides the
cabinet will be double counted if the goods moved from the cabinet, and the
camera treats the cabinet (on which the good removed) as a new scene. The
default value of 50 is recommended.
Scene Change Level [0~100]: It refers to level of the camera responses to the
dynamic environment, e.g., a swaying curtain. The camera may treat the
swaying curtain as a target. Setting the level properly will avoid the