User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Chapter 1 Product Introduction
- Chapter 2 Start Up Device
- Chapter 3 Basic Operation
- Chapter 4 Network
- Chapter 5 Live View and Configuration
- Chapter 6 Mobile Device Features
- Chapter 7 Camera Management
- Chapter 8 Driving Behavior Configuration
- Chapter 9 Events and Alarms
- Chapter 10 Security
- Chapter 11 Maintenance
- Chapter 12 Local Menu Operation
4) Enter SSID.
5) Select Network Mode as Managed.
6) Select Security Mode and enter Wi-Fi key.
4. Click Save.
5.
Oponal: Go to Conguraon → Network → Advanced Sengs → Wi-Fi → Wi-Fi Status to
view Wi-Fi status.
4.1.3 Set Local Network
Congure local network parameters.
Steps
1. Go to Conguraon → Network → Basic Sengs → TCP/IP .
2. Select LAN port.
-
Debug Interface: Used to debug the recorder.
-
Rear interface: Used to connect network cameras.
3. Enter network parameters: IPv4 Address, IPv4 Subnet Mask, and IPv4 Default Gateway.
4. Oponal: To access the recorder via internet, congure DNS server.
5. Click Save.
4.1.4 Port
Conguraon
Go to Conguraon → Network → Basic Sengs → Port .
HTTP Port
Used to access the recorder via web browser.
RTSP Port
Used to get stream.HTTPS Port
HTTPS Port
Used for secure
communicaon over a network.
Server Port
Used to access the recorder via client soware.
4.1.5 DDNS
Conguraon
If your recorder external network is a dynamic IP address, you can use the Dynamic DNS (DDNS) for
network access.
Before You Start
• Register your recorder on the DDNS server.
•
Congure local network IP address, subnet mask, gateway, and DNS server.
• Create port mapping, default port:80, 8000, and 554.
Mobile Video Recorder User Manual
12