User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Symbol Conventions
- Chapter 1 Product Introduction
- Chapter 2 Start Up Device
- Chapter 3 Basic Operation
- Chapter 4 Network
- Chapter 5 Live View and Configuration
- Chapter 6 Mobile Device Features
- Chapter 7 Camera Management
- Chapter 8 Driving Behavior Configuration
- Chapter 9 Events and Alarms
- Chapter 10 Security
- Chapter 11 Maintenance
- Chapter 12 Local Menu Operation
Chapter 9 Events and Alarms
9.1 Congure Moon Detecon Alarm
When moon detecon alarm is congured, once a moon event is detected, the device starts to
record and mulple linkage acons will be triggered.
Steps
1. Go to Conguraon → Event → Basic Event → Moon Detecon .
2. Select Channel No.
3. Draw
detecon area.
1) Click Draw Area.
2) In preview area, drag to draw the
detecon area.
3) Click Stop Drawing.
4.
Congure arming schedule. For detailed steps, refer to Congure Arming Schedule .
5. Congure linkage method. For detailed steps, refer to Congure Linkage Acons .
6. Set Sensivity.
7. Click Save.
9.2
Congure Video Loss Alarm
When the recorder cannot receive video signal from the analog cameras, the video loss alarm will
be triggered. Linkage acons, including audible warning and alarm output, can be set to respond.
Steps
1. Go to Conguraon → Event → Basic Event → Video Loss .
2. Check Enable Video Loss
Detecon.
3. Congure arming schedule. For detailed steps, refer to Congure Arming Schedule .
4.
Congure linkage method. For detailed steps, refer to Congure Linkage Acons .
5. Click Save.
9.3
Congure Video Tampering Alarm
A tampering alarm is triggered when the camera is covered and the monitoring area cannot be
viewed. Linkage
acons, including audible warning, alarm output, can be set to respond.
Steps
1. Go to Conguraon → Event → Basic Event → Video Tamptering .
2. Select Channel No.
3. Draw
detecon area.
1) Click Draw Area.
2) In preview area, drag to draw the detecon area.
Mobile Video Recorder User Manual
28