User Manual
Table Of Contents
- Chapter1 Introduction
- Chapter2 Keyboard Configuration
- Chapter3 Keyboard Operation
- Appendix 1: Specifications
- Appendix 2: FTP Upgrade
User Manual of DS-1100KI Network Keyboard
23
3.2.2.4 Camera Group to Window
The video signal from the camera group can be outputted to and displayed on the selected window of monitor in
cycle.
Note: The default dwell time for the cycle view is 30 sec.
Operation:
1. Press the Num + MON keys to select the monitor.
2. Press the Num + WIN keys to select the display
window on the monitor.
3. Press the Num + CAM-G keys to select the camera
group.
Example: User can input the “1+MON, 2+WIN,
3+CAM-G” keys to decode the video signal from camera
group 3 and display it on window 2 of the monitor 1.
Note: Note: In the local preview mode when user inputs
0+MON
keys, the cycle view function is not supported.
When user presses the 0+CAM keys, it will stop the
dynamic decoding of the current window.
Note: Corresponding error message will appear on the screen when user performs wrong operation.
3.2.2.5 Camera Group to Monitor Group
The selected camera group signal can be outputted and displayed by the decoding channel on the selected
monitor group.
1. When the number of cameras in the camera group is equal to or less than the number of monitors in the
monitor group, e.g., 8 cameras9 monitors, then each camera will be displayed on its corresponding monitor
respectively, e.g., camera 1 on monitor 1, and camera 8 on monitor 8, etc.
2. When the number of cameras in the camera group is more than the number of monitors in the monitor group,
e.g., 34 cameras16 monitors, then the camera 1-16 will be displayed on monitor 1-16, camera 17-32 on
monitor 1-16, and camera 33-34 on window 1-2 in cycle view mode.
Note: The default dwell time of cycle view is 30 sec.
Operation:
1. Press the Num + MON-G keys to select the monitor
group.
2. Press the Num + CAM-G keys to select the camera
group to be viewed in cycle on the specified
monitor group.
Note: In this operation mode, each output channel in
the selected monitor group will be displayed on the
screen in 1-division mode by default.
3.2.2.6 Set Tour
Up to 64 cameras can be set in a tour, with the dwell time configurable. The default dwell time is 30 seconds.
When the system is not in the playback mode, user can directly press the SET key then the Num + TOUR keys to
enter the tour settings interface.