User Manual

Network Security Control Panel User Manual

Chapter 2 System Controlling

2.1 Keypad Operation Code

Single Partition Mode

Default Status: the control is in the single partition mode, that is, only partition 1 is enabled.

Multi-Partitions Mode

1) In the multi-partitions mode (equal to or more than 2 partitions), there are 2 modes

for keypad operations: global keypad mode, and partition keypad mode.

 Global Keypad Mode: In this mode, the user does not enter the partition. The

object of keypad operation is the whole system of the control panel.

 Partition Keypad Mode: In this mode, the user enters the partition. The object of

keypad operation is the partition that the user enters.

 When initializing the device, the partition 1 is enabled and the global keypad mode

is disabled by default. The global keypad enters the partition mode, and cannot be

switched into the global mode. The system will enable the global mode

automatically unless the partition except for partition 1 is enabled.

 The command for entering partition is “*3n#”, in which the range of n is from 1 to

8, standing 8 partitions.

 The command for exiting partition is “*#”.

2) Only the administrator and the installer have the permission to operate the global

keypad. On the global keypad, the administrator can view and operate all partitions and the

whole control panel system.

3) When operating on the partition keypad, the administrator can only operate the

partition which the keypad belongs to.

2.1.1 Device Initialization

Function: The control panel can be recovered through the alarm keypad initialization.

Command:［Installer Password］ + ［*］ + ［8］ + ［9］ + ［#］