User Manual

Network Security Control Panel User Manual

2.1.13 Changing User Password via Master Code

Function: You can change the user password of the keypad via the master code.

Command:

［Master Code］ + ［*］ + ［0］ + ［#］

［User No.］ + ［#］

［New Password］ + ［#］

The user password will be changed by the above four steps.

2.1.14 Adding/Deleting Keyfob

Adding Keyfob

Function: You can match the codes of the keyfob with ones of the control panel via the

keypad.

1. Enter the code matching mode. If the partition No. is not set, the keyfob will

be added to partition 1.

Command:

[User Password] + [ * ] + [ 9 ] + [ 1 ] + [Keyfob No.] + [ # ]

[User Password] + [ * ] + [ 9 ] + [ 1 ] + [Keyfob No.] +[Partition No.] + [ # ]

Press the new password of the

appointed user again: [5] [6] [7] [8].

xxxx

Press [#] to confirm the new password.