User Manual

Network Security Control Panel User Manual
39
Display English
Command: [ * ] + [ 9 ] + [ 1 ] + [ 1 ] + [ # ]
Display Chinese
Command: [ * ] + [ 9 ] + [ 1 ] + [ 0 ] + [ # ]
2.1.22 Zone Testing
Enter the Testing Mode
Function: The zone testing function is used for keypad debugging.
Command:［Installer Password］ + ［*］ + ［6］ + ［0］ + ［#］
Demonstration:
E.g., the user
password is 1234.
LCD Display
Press the user
password: [1] [2] [3]
[4].
xxxx*60
Press [*] to enter the
working mode.
Press [6] [0] to enter
the zone testing
mode.
Press [#] to confirm
the operation.
If the operation is successful,
Operation Succeeded
If the operation is failed,
Operation Failed
Exit the Testing Mode
Command:［Installer Password］ + ［*］ + ［6］ + ［2］ + ［#］
 The function of zone testing is only available under the status of disarming and non-fault
of the zone. The system will do auto-arming in the zone testing mode without reporting
any CID log. The siren will start warning after the alarm is triggered and stop warning if