User Manual

Network Security Control Panel User Manual
51
to disarm;
1) Initialize the hardware, restore the password of operator, main operator password
and permission, and then disarm with main operator. The initialization password of
operator is: 012345, the initialization password of main operator is: 1234, the
permission is: arm/disarm. There is arm/disarm report and bypass is permitted.
Please refer to FAQ of hardware initialization for more information about hardware
initialization.
2) The command code to restore factory parameters: {Password of operator} + {*} + {8}
+ {9} + {#}.
This method is not recommended because it will initialize all programming
contents.
Q: How to do the hardware initialization?
A: Control panel hardware initialization only initializes operator password: 012345 and main
operator password: 1234, main operator permission is arm/disarm. There are
arming/disarming report and allows bypass.
Steps:
1) Power off the control panel and open the cover;
2) Short the restore switch of the control panel with shorting nut or connection cables;
3) Power on the control panel and power off it 10s later;
4) Please remove the shorting nut or connection cable on the restore switch;
5) Cover the control panel well;
6) Recharge the control panel;
Q: Why is there no response for keypad operational order but alert sound of error 10s later?
A: It may be caused by follow situations:
1) Poor contact of the connection cable between LED keypad and the control panel,
please check if the cable is normal;
2) The LED keypad is considered as off-line in the communication. If there is other
keypad operates normal, process program command {Main Operator Password} + {*}
+ {6} + {8} + {#}to restore it or power off the control panel and reboot.
Q: How does the control panel detect alternating current, storage battery, control panel
tamper-proof and ADSL cable?
A: The status of the control panel detection is as follows:
1) The control panel detects AC power supply status once in a while;
2) The control panel detects storage battery status once in a while;
3) The control panel detects tamper-proof status once in a while;
4) The control panel detects ADSL cable status once in a while.
Q: The network is disconnected.
A：
1) Please check if the network status indicator of the board is normal on;
2) If the network status indicator is not normal on, please check if the network cable
connection is normal.