User Manual

Network Security Control Panel User Manual
vi
heating and can be a fire hazard.
 When the product is installed on a wall or ceiling, the device should be firmly fixed.
 To reduce the risk of fire or electrical shock, do not expose the indoor used product to rain or
moisture.
 This installation should be made by a qualified service person and should conform to all the
local codes.
 Please install blackouts equipment into the power supply circuit for convenient supply
interruption.
 If the product does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the product yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.)
 Please do not look directly into the laser light within 6 meters because laser is hazardous to
humans.
Cautions:
 Make sure the power supply voltage is correct before using the product.
 Do not drop the product or subject it to physical shock. Do not install the product on vibratory
surface or places.
 Do not expose it to high electromagnetic radiating environment.
 Do not aim the lens at the strong light such as sun or incandescent lamp. The strong light can
cause fatal damage to the product.
 The sensor may be burned out by a laser beam, so when any laser equipment is being used,
make sure that the surface of the sensor not be exposed to the laser beam.
 For working temperature, please refer to the specification manual for details.
 To avoid heat accumulation, good ventilation is required for a proper operating environment.
 While shipping, the product should be packed in its original packing.
 Please use the provided glove when open up the product cover. Do not touch the product
cover with fingers directly, because the acidic sweat of the fingers may erode the surface
coating of the product cover.
 Please use a soft and dry cloth when clean inside and outside surfaces of the product cover.
Do not use alkaline detergents.