Quick Start Guide

HD-TVI Speed Dome·Quick Start Guide
13
surrounding, electromagnetic interference, etc..
 Choose the cable with nominal voltage higher than the actual voltage to guarantee a normal
running.
 To protect the power cable and the signal transmitting cable from human tampering, you should
pay attention to the protection and reinforcement of the cables.
 When wiring, do not tighten the wire or loosen the wire.
The wiring of the speed dome should be performed by professionals.
1.3.2 Installing the Mount
Before you start:
Wall mounting is applicable for the indoor/outdoor solid wall. The followings are the mandatory
precondition for wall mounting:
 The wall must be thick enough to install the expansion screws.
 Make sure that the wall is strong enough to withstand more than 8 times the weight of the dome
and the mount.
Steps:
1. Make sure that the type of the mount, and the number of accessories are right, as shown in the
figure below.
Figure 1-12 Wall Mount, Nuts, and Flat Washers
2. Drill 4 screw holes in the wall according to the holes of the mount, and then insert expansion
screws into the screw holes.
Figure 1-13 Drill Mounting Holes
3. Attach the wall mount to the wall by aligning the 4 screw holes of the mount with expansion
screws on the wall.
4. Secure the wall mount with 4 hex nuts and washers.