Quick Start Guide

HD-TVI Speed Dome·Quick Start Guide
17
Figure 2-2 Draw and Cut Hole on the Ceiling
6. Connect the cables.
(1) Make sure the video cable and control wire have been connected to the corresponding
interface.
(2) Connect the power cable, and the red LED indicator turns on when the power is on.
Turn the power off after checking the speed dome.
7. Install the speed dome.
(1) Loosen the two lock screws on both sides of the back box and make the locks in internal
position, as shown in the following figure:
Lock
Lock
Figure 2-3 Locks and Lock Screws
(2) Push the back box into the mounting hole in the ceiling.
(3) Tighten the lock screws with the screwdriver and the locks will automatically rotate outwards
to secure the in-ceiling mount to the ceiling.
Ceiling
Lock
Lock
Figure 2-4 Install the back box