Quick Start Guide

HD-TVI Speed Dome·Quick Start Guide
20
Figure 2-9 Cabling for Ceiling Mounting
2.2.3 Ceiling Mounting
Steps:
1. Rotate the lower dome counterclockwise to separate it from the back box. Refer to the Figure 2-
1.
2. Remove the protective lens cover, foam and sticker from the dome drive.
3. Set the address and baudrate for the analog speed dome. Please refer to the Section 1.2.1 5-
inch Speed Dome Settings for DIP switch settings.
4. Attach lower dome to the back box, and rotate clockwise to secure it.
5. Use the mounting base as a template to mark four screw holes onto the ceiling.
6. If you route cables from the top of the back box, mark the cable hole on the ceiling and drill a
hole.
Figure 2-10 Mark the Screw Positions
7. Secure the mounting base to the ceiling with set screws.
 If the speed dome is installed to the wooden ceiling, use the self-tapping screws to secure
the mounting base.
 If the dome is installed to the cement ceiling, drill three Ø 5 mm mounting holes onto the
ceiling according to the hole’s locations, and then insert the cement screws into the holes
and finally use self-tapping screws to secure the mounting base to the ceiling.