User Manual

24
2) Tighten the No.1 adjusting screw.
3) Loosen the No.2 adjusting screw to adjust the tilting
position [0° to 90°].
4) Tighten the No. 2 adjusting screw.
5) Loosen the No.3 adjusting screw to adjust the rotation
position [0° to 360°].
6) Tighten the No.3 adjusting screw.
0° to 90°
0° to 360°
0° to 360°
3
2
1
Figure 2. 16 3-Axis Adjustment
2.2.2 Mounting with Junction Box
Note:
You need to purchase a junction box separately if you adopt the
mounting with a junction box.
Steps:
1. Attach the drill template on the wall/ceiling.
2. Drill screw holes and the cable hole in the wall/ceiling
according to the holes of the drill template.
3. Attach the junction box to the wall/ceiling by aligning the
screw holes of the junction box.
4. Secure the junction box with the PA4 × 25 screws on the
wall/Ceiling.