User Manual

• Improper replacement of the
baery with an incorrect type may defeat a safeguard (for
example, in the case of some lithium baery types).
• Do not dispose of the baery into re or a hot oven, or mechanically crush or cut the baery,
which may result in an explosion.
• Do not leave the
baery in an extremely high temperature surrounding environment, which may
result in an explosion or the leakage of
ammable liquid or gas.
• Do not subject the baery to extremely low air pressure, which may result in an explosion or the
leakage of
ammable liquid or gas.
• +
idenes the posive terminal(s) of equipment which is used with, or generates direct current.
- idenes the negave terminal(s) of equipment which is used with, or generates direct current.
Fire Prevenon
• No naked ame sources, such as lighted candles, should be placed on the equipment.
• The serial port of the equipment is used for debugging only.
Hot Surface Prevenon
•
CAUTION: Hot parts! Burned ngers when handling the parts. Wait one-half hour
aer switching o before handling parts. This scker is to indicate that the marked item can be
hot and should not be touched without taking care. For device with this
scker, this device is
intended for installaon in a restricted access locaon, access can only be gained by service
persons or by users who have been instructed about the reasons for the
restricons applied to
the locaon and about any precauons that shall be taken.
Installaon
• Install the equipment according to the instrucons in this manual.
• To prevent injury, this equipment must be securely aached to the oor/wall in accordance with
the
installaon instrucons.
• Never place the equipment in an unstable locaon. The equipment may fall, causing serious
personal injury or death.
Power Supply
• The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and
the Limited Power Source. Refer to the appropriate documentaon for detailed informaon.
• The power source should meet limited power source or PS2 requirements according to IEC
60950-1 or IEC 62368-1 standard.
• DO NOT connect
mulple devices to one power adapter, to avoid over-heang or re hazards
caused by overload.
• Make sure the plug is properly connected to the power socket.
Network Camera User Manual
v