User Manual

Note
Up to 8 license plates are supported.
10.
Set arming schedule and linkage method. For the arming schedule sengs, refer to Set Arming
Schedule . For the linkage method sengs, refer to Linkage Method Sengs .
11.
Click Save.
Set Mixed-Trac Detecon Rule
The motor vehicles and non-motor vehicles that enter the set lane can be detected, and the
picture of targets can be captured and stored. Alarms will be triggered and captures can be
uploaded.
Before You Start
Go to VCA → VCA Resources , and select Road
Trac.
Steps
1.
Go to VCA → Road Trac → Detecon Conguraon , and select Mixed-trac Detecon as
detecon type.
2.
Check Enable.
3.
Select the total number of lanes.
4.
Click and drag the lane line to set its
posion, or click and drag the line end to adjust the length
and angle of the line.
5.
Adjust the zoom
rao of the camera so that the size of the vehicle in the image is close to that of
the red frame. Only the posion of red frame is adjustable.
Note
Only 1 license plate can be captured at one me for each lane.
6.
Select Region and Country/Region.
7.
Check Remove Duplicated License Plates ans set Time Interval. The default me interval is 4
minutes.
Note
Up to 8 license plates are supported.
8.
Set arming schedule and linkage method. For the arming schedule sengs, refer to Set Arming
Schedule . For the linkage method sengs, refer to Linkage Method Sengs .
9.
Click Save.
Uploading Pictures
Sengs
You can set the image parameters of the captured images in vehicle detecon and mixed-trac
detecon.
Go to VCA → Road Trac → Picture .
Network Camera User Manual
93