User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- Chapter 7 Network Settings
- 7.1 Configuring Basic Settings
- 7.2 Configure Advanced Settings
- 7.2.1 Configuring SNMP Settings
- 7.2.2 Configuring FTP Settings
- 7.2.3 Configuring Email Settings
- 7.2.4 Platform Access
- 7.2.5 Wireless Dial
- 7.2.6 HTTPS Settings
- 7.2.7 Configuring QoS Settings
- 7.2.8 Configuring 802.1X Settings
- 7.2.9 Integration Protocol
- 7.2.10 Bandwidth Adaptation
- 7.2.11 Network Service
- 7.2.12 Smooth Streaming
- Chapter 8 Video/Audio Settings
- Chapter 9 Image Settings
- Chapter 10 Event Settings
- 10.1 Basic Events
- 10.2 Smart Events
- 10.2.1 Configuring Audio Exception Detection
- 10.2.2 Configuring Defocus Detection
- 10.2.3 Configuring Scene Change Detection
- 10.2.4 Configuring Face Detection
- 10.2.5 Configuring Intrusion Detection
- 10.2.6 Configuring Line Crossing Detection
- 10.2.7 Configuring Region Entrance Detection
- 10.2.8 Configuring Region Exiting Detection
- 10.2.9 Configuring Unattended Baggage Detection
- 10.2.10 Configuring Object Removal Detection
- 10.3 VCA Configuration
- Chapter 11 Storage Settings
- Chapter 12 Playback
- Chapter 13 Picture
- Chapter 14 Application
- Appendix
Network Camera User Manual
168
trigger one notification.
ii. Set regional people queuing-up settings.
Check OSD to display the region name and its real-time queuing-up
people number.
Alarm Trigger Condition: When the people number in the region is
greater than, less than, equal to or not equal to the set threshold, an alarm
is triggered.
Alarm threshold: An alarm is triggered when the alarm threshold
condition is met.
iii. Set waiting time detection settings.
Alarm Trigger Condition: When the people number in the region is
greater than, less than, equal to or not equal to the set threshold, an alarm
is triggered.
Alarm threshold: An alarm is triggered when the alarm threshold
condition is met.
c) Repeat above steps to set up other regions if needed. Up to 3 regions are
supported.
2. Arming Schedule.
Set the arming schedule for the function. In the armed periods, the function is
active. Refer to Task 2 in Section 10.1.1.
3. Linkage Method. Set linkage method.
For triggered alarm information, you can set the linkage action as a response to
forward the information or trigger other actions. Refer to Task 3 in Section 10.1.1.
4. Advanced Configuration.
(Optional) Check the queue management version and set the filtering parameters.
Note: The function changes the detection range and the sensitivity of the queue
management. Remain filter settings unchanged in general situations. You are
recommended to ask the professional technical supports for help to set the filter
parameters if necessary.