User Manual

6. Click Save.
6.1.3 Set PIR Alarm
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector's eld of
view. The heat energy dissipated by a person, or any other warm blooded creature such as dogs,
cats, etc., can be detected.
Steps
Note
Only certain models support PIR alarm.
1. Go to Conguraon → Advanced Conguraon → Basic Event → PIR Alarm .
2. Check Enable PIR Alarm.
3. Refer to Set Arming Schedule for
seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
4. Click Save.
6.1.4 Set
Excepon Alarm
Excepon such as network disconnecon can trigger the device to take corresponding acon.
Steps
1. Go to
Conguraon → Event → Basic Event → Excepon .
2. Select Excepon Type.
HDD Full
The HDD storage is full.
HDD Error Error occurs in HDD.
Network Disconnected The device is oine.
IP Address Conicted The IP address of current device is same as that of other device in
the network.
Illegal Login Incorrect user name or password is entered.
Voltage Instable The power supply voltage is uctuang.
3. Refer to Linkage Method Sengs for seng linkage method.
4. Click Save.
6.1.5 Set Alarm Input
Alarm signal from the external device triggers the corresponding acons of the current device.
Network Camera User Manual
40