User Manual

Figure 6-5 Set Rule
5. Oponal: You can set the parameters of mulple areas by repeang the above steps.
6. For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method
sengs, refer to Linkage Method Sengs .
7. Click Save.
6.2.9 Set Region
Exing Detecon
It is used to detect objects exing from a pre-dened virtual region. If it occurs, the device can take
linkage
acons.
Steps
1. Go to
Conguraon → Event → Smart Event → Region Exing Detecon
2. Check Enable.
3. Select one Region. For the
detecon region sengs, refer to Draw Area .
4. Set the detecon target, sensivity and the target validity.
Sensivity
It stands for the percentage of the body part of an acceptable target that
goes across the pre-dened region. Sensivity = 100 - S1/ST × 100. S1 stands
for the target body part that goes across the pre-dened region. ST stands
for the complete target body. The higher the value of
sensivity is, the more
easily the alarm can be triggered.
Detecon
Target
Human and vehicle are available. If the detecon target is not selected, all
the detected targets will be reported, including the human and vehicle.
Target
Validity
If you set a higher validity, the required target features should be more
obvious, and the alarm accuracy would be higher. The target with less
obvious features would be missing.
Network Camera User Manual
48