User Manual

Table Of Contents
Network Camera User Manual
89
Display smart information on stream, including the target and rules information.
Display Target info. on Alarm Picture
Overlay the alarm picture with target information.
Target Picture Settings
Custom, Head Shot, Half-Body Shot and Full-Body Shot are selectable.
Note
If you select Custom, you can customize width, head height and body height as required.
You can check Fixed Value to set the picture height.
Background Picture Settings
Comparing to target picture, background picture is the scene image offers extra environmental
information. You can set the background picture quality and resolution. If the background image
need to be uploaded to surveillance center, check Background Upload.
People Counting Overlay
Select flow overlay type.
Select the daily reset time. Click Manual Reset if you want to reset right now.
Camera
You can set Device No. and Camera Info. for the camera, which can be overlaid on captured
picture.
Text Overlay
You can check desired items and adjust their order to display on captured pictures by .
The content of Device No. and Camera Info should be on the same page.
10.2.3 Face Capture Algorithms Parameters
It is used to set and optimize the parameters of the algorithm library for face capture.
Go to Configuration Face Capture Advanced Configuration Parameters.
Face Capture Version
It lists the version of the algorithms library.
Detection Parameters
Generation Speed
The speed to identify a target. The higher the value, the faster the target will be recognized.
Setting the value quite low, and if there was a face in the configured area from the start, this
face will not be captured. It can reduce the misinformation of the faces in the wall painting or
posters. The default value of 3 is recommended.
Sensitivity