User Manual

Table Of Contents
Network Camera User Manual
93
10.3.2 Set Mixed-Traffic Detection Rule
The motor vehicle, non-motor vehicle, and pedestrian that enter the set lane can be detected, and
the picture of targets can be captured and stored. Alarm will be triggered and capture can be
uploaded.
Before You Start
Go to Configuration System System Settings VCA Resources, ad select Road Traffic.
Steps
1. Go to Configuration Road Traffic Detection Configuration, and select Mixed-traffic
Detection as detection type.
2. Check Enable.
3. Select the lane number.
4. Select Region and Country/Region.
5. Set arming schedule and linkage method. For the arming schedule settings, refer to Set Arming
Schedule. For the linkage method settings, refer to Linkage Method Settings.
6. Click Save.
10.3.3 Uploading Pictures Settings
You can set the image parameters of the captured images in vehicle detection and mixed-traffic
detection.
Go to Configuration Road Traffic Picture.
Picture Quality
The larger the value is, the clearer the picture is, but larger storage space is also required.
Picture Size
The larger the value is, the larger the storage space is needed. And the level of network
transmission requirement is also higher.
License Plate Enhancement
The larger the value is, the clearer the license plate is, but larger storage space is also required.
Check License Plate Enhancement and set the level. The default level is 50.
Overlay
You can overlay camera, device or vehicle information on the captured image and click to
adjust the order of overlay texts.
For camera settings, go to Configuration Road Traffic Camera to set relevant parameters
and click Save.
10.3.4 Camera Settings
You can set the parameters of each camera for better management.
Go to Configuration Road Traffic Camera to set relevant parameters and click Save.