User Manual

Network Camera User Manual
41
6.1.6 Set Video Quality Diagnosis
When the video quality of the device is abnormal and the alarm linkage is set, the alarm will be
triggered automatically.
Steps
1. Go to Configuration → Event → Basic Event → Video Quality Diagnosis.
2. Select Diagnosis Type.
3. Set the corresponding parameters.
Alarm Detection Interval
The time interval to detect the exception.
Sensitivity
The higher the value is, the more easily the exception will be detected, and the higher
possibility of misinformation would be.
Alarm Delay Times
The device uploads the alarm when the alarm reaches the set number of times.
4. Check Enable, and the selected diagnosis type will be detected.
5. Set arming schedule. See Set Arming Schedule.
6. Set linkage method. See Linkage Method Settings.
7. Click Save.
Note
The function is only supported by certain models. The actual display varies with models.
6.1.7 Set Vibration Detection
It is used to detect whether the device is vibrating. The device reports an alarm and triggers
linkage actions if the function is enabled.
Steps
1. Go to Configuration → Event → Basic Event → Vibration Detection.
2. Check Enable.
3. Drag the slider to set the detection sensitivity. You can also enter number to set the sensitivity.
4. Set the arming schedule. See Set Arming Schedule.
5. Set the linkage method. See Linkage Method Settings.
6. Click Save.
Note
The function is only supported by certain models. The actual display varies with models.