User Manual
Table Of Contents
- Chapter 1 System Requirement
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Camera
- Chapter 4 Wi-Fi Settings
- Chapter 5 Live View
- Chapter 6 Network Camera Configuration
- Chapter 7 Network Settings
- 7.1 Configuring Basic Settings
- 7.2 Configure Advanced Settings
- 7.2.1 Configuring SNMP Settings
- 7.2.2 Configuring FTP Settings
- 7.2.3 Configuring Email Settings
- 7.2.4 Platform Access
- 7.2.5 Wireless Dial
- 7.2.6 HTTPS Settings
- 7.2.7 Configuring QoS Settings
- 7.2.8 Configuring 802.1X Settings
- 7.2.9 Integration Protocol
- 7.2.10 Bandwidth Adaptation
- 7.2.11 Network Service
- 7.2.12 Smooth Streaming
- Chapter 8 Video/Audio Settings
- Chapter 9 Image Settings
- Chapter 10 Event Settings
- 10.1 Basic Events
- 10.2 Smart Events
- 10.2.1 Configuring Audio Exception Detection
- 10.2.2 Configuring Defocus Detection
- 10.2.3 Configuring Scene Change Detection
- 10.2.4 Configuring Face Detection
- 10.2.5 Configuring Intrusion Detection
- 10.2.6 Configuring Line Crossing Detection
- 10.2.7 Configuring Region Entrance Detection
- 10.2.8 Configuring Region Exiting Detection
- 10.2.9 Configuring Unattended Baggage Detection
- 10.2.10 Configuring Object Removal Detection
- 10.3 VCA Configuration
- Chapter 11 Storage Settings
- Chapter 12 Playback
- Chapter 13 Picture
- Chapter 14 Application
- Appendix
Network Camera User Manual
181
3. Select Statistics Time.
4. Click Counting to generate the report.
5. (Optional) Click Export in the upper right corner to export the data in desired
format (.txt and xls. are selectable.).
Raw Data
Storage of Raw Data
Raw data of queue management is saved in local storage of the device.
With an on-board memory card installed, the device can save up to one mouth’s data.
With NO memory card installed, the device can only save up to one week’s data.
Raw Data Exporting
Raw data exporting of queue management is not available on web browser. For
further analysis, you can get the data via RTSP protocol.
Open Platform
Purpose:
Open platform allows you to install the application for the third-party function
development.
Note:
Only certain camera models support the function, and the actual display may vary
with your camera model.
When you use the open platform function, it is not recommended to set your IP
address and the camera IP address to 192.168.252.X.
Steps:
1. Enter the Record Schedule Settings interface: Configuration > Open Platform.