Bullet Network Camera Quick Start Guide COPYRIGHT © 2017 Hikvision.
Quick Start Guide ALL RIGHTS RESERVED Any and all information, including, among others, wordings, pictures, graphs are the properties of Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries (hereinafter referred to be “Hikvision”). This user manual (hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision.
DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE OF THIS PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS.
—Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help FCC conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2.
e f l Safety Instruction These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss. Laws and Regulations The device should be used in compliance with local laws, electrical safety regulations, and fire prevention regulations. Transportation Keep the device in original or similar packaging while transporting it. Power Supply The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and the Limited Power Source.
Cleaning Please use a soft and dry cloth when clean inside and outside surfaces of the product cover. Do not use alkaline detergents. Using Environment When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it may burn out. Do not expose the device to high electromagnetic radiation or dusty environments. For indoor-only device, place it in a dry and well-ventilated environment. Do not aim the lens at the sun or any other bright light.
Be sure that there is enough space to install the camera and accessories. Make sure that the device in the package is in good condition and all the assembly parts are included. Make sure that the wall is strong enough to withstand at least 4 times the weight of the camera and the mount. The standard power supply is 12 VDC, or PoE (802.3at), please make sure your power supply matches with your camera. Make sure that the power has been disconnected before you wire, install, or disassemble the device.
i. Not necessarily included accessory. ii. Variable accessory amount. iii. Skip this step if not required.
HIKVISION 1x 1x 2x* 1x 1x T20 T10 1x 1x 1x 1 1x
1.
HIKVISION 1.
HIKVISION 2.
HIKVISION A.1 A.2 5.
HIKVISION A.3 A.4 5.0 2.
HIKVISION B.1 B.
HIKVISION B.3 5.5mm B.4 5.0 2.
HIKVISION 2.2 A.4 B.4 5.
HIKVISION 10
HIKVISION 2.
HIKVISION 2.5 2.6 2.
HIKVISION 2.
HIKVISION 2.
HIKVISION 2.
HIKVISION 2.
HIKVISION 2.
HIKVISION 3.1 3.
HIKVISION 3.
HIKVISION 3.
HIKVISION 3.
HIKVISION 3.
HIKVISION 4.
HIKVISION 5.1 Activate and Access Network Camera Scan the QR code to get Activate and Access Camera. Note that mobile data charges may apply if Wi-Fi is unavailable.
UD08009B