Operation Manual

User Manual of Network Camera

Figure 6-17 FTP Settings

2. Configure the FTP settings; and the user name and password are required for

Directory: In the Directory Structure field, you can select the root directory,

parent directory and child directory. When the parent directory is selected, you

have the option to use the Device Name, Device Number or Device IP for the

name of the directory; and when the Child Directory is selected, you can use the

Camera Name or Camera No. as the name of the directory.

Upload type: To enable uploading the captured picture to the FTP server.

Anonymous Access to the FTP Server (in which case the user name and

password won’t be requested.): Check the checkbox to enable

the anonymous access to the FTP server.

Note: The anonymous access function must be supported by the FTP server.

3. Click to save the settings.

Notes: If you want to upload the captured pictures to FTP server, you have to

enable the continuous snapshot or event-triggered snapshot on Snapshot page.

For detailed information, please refer to the Section 6.6.8.

6.3.9 Configuring UPnP™ Settings

Universal Plug and Play (UPnP™) is a networking architecture that provides

compatibility among networking equipment, software and other hardware devices.

The UPnP protocol allows devices to connect seamlessly and to simplify the

implementation of networks in the home and corporate environments.

With the function enabled, you don’t need to configure the port mapping for each

port, and the camera is connected to the Wide Area Network via the router.

Steps:

1. Enter the UPnP™ settings interface.

Configuration >Advanced Configuration > Network > UPnP

2. Check the checkbox to enable the UPnP™ function.

The name of the device when detected online can be edited.