User Manual

Installation
2.1 Installation Preparation
Before you start:
 Make sure that the device in the package is in good
condition and all the assembly parts are included.
 Make sure that all the related equipment is power-off
during the installation.
 Check the specification of the products for the
installation environment.
 Check whether the power supply is matched with
your power output to avoid damage.
 Make sure the wall is strong enough to withstand
three times the weight of the camera and the
mounting bracket.
 If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
 If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.2 Installation of Type I Camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the bullet camera. Ceiling mounting will be taken as
an example in this section. You can take the steps of
ceiling mounting as a reference, when adopting the wall
mounting.
Steps:
1. Paste the dill template to the ceiling.
2. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
47.6
13.7
27.5
Φ
68
3
-
Φ
4
Unit： mm
Figure 2. 1 Drill Template
Note:
Cable hole is required when adopting ceiling outlet
to route the cable.
3. Attach the mounting base of the type I camera to
the ceiling and secure the camera with supplied
screws.