User Manual

1 Introduction
1.1 Product Features
The camera is applicable for both indoor and outdoor
conditions, and the application scenarios include road,
warehouse, underground parking lot, bar, etc..
The main features are as follows:
 High performance CMOS sensor
 Low illumination, 0.01 Lux@(F1.2, AGC ON), 0 Lux
with IR
 IR cut filter with auto switch
 OSD menu with configurable parameters
 Auto white balance
 internal synchronization
 SMART IR mode
 PoC (with -E)
 3-axis adjustment
Note:
Type II camera is applicable to indoor only.
1.2 Overview
Before you start:
 The device cables vary according to different models.
The cables of each type are shown in the figures
below, refer to the actual device.
 You can debug the camera by connecting an auxiliary
HD TVI cable to the auxiliary video output.
1.2.1 Overview of Type I Camera
Bubble
Auxiliary
Video Output
Lens
Back Box
Menu Button
Video Cable
24 VAC/12 VDC
Power Cord
Cables
Video Cable
12 VDC Power Cord
Model I Cables
Model II Cables
Figure 1-1 Overview of Type I Camera
1.2.2 Overview of Type II Camera
Bubble
Auxiliary
Video Output
Lens
Back Box
Menu Button
Video Cable
24 VAC/12 VDC
Power Cord
Cables
Video Cable
12 VDC Power Cord
Model I Cables
Model II Cables
Base Plate
Figure 1-2 Overview of Type II Camera
2 Installation
Before you start:
 Make sure that the device in the package is in good
condition and all the assembly parts are included.
 Make sure that all the related equipment is
power-off during the installation.