User Manual

 Check the specification of the products for the
installation environment.
 Check whether the power supply is matched with
your power output to avoid the damage.
 Make sure the wall is strong enough to withstand
three times the weight of the camera and the
bracket.
 If the wall is cement, you need to insert expansion
bolts before you install the camera. If the wall is
wooden, you can use self-tapping screws to secure
the camera.
 If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance
by yourself.
2.1 Ceiling Mounting
Before you start:
Both wall mounting and ceiling mounting are suitable
for the dome camera. Ceiling mounting will be taken as
an example in this section. You can take steps of ceiling
mounting as a reference for wall mounting.
Steps:
1. Paste the drill template to the celling.
2. Drill screw holes and the cable hole (optional) on
the ceiling according to the supplied drill template.
Type I Camera
Type II Camera
Figure 2-1 The Drill Template
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Loosen the screws on the bubble of the dome
camera to remove the bubble and the black liner.
4. Attach the back box of type I camera/base plate of
type II camera to the ceiling and secure them with
supplied screws.
Type I Camera
Type II Camera
Figure 2-2 Attach the Back Box/Base Plate
Note:
 In the supplied screw package, both self-tapping
screws and expansion bolts are contained.
 For cement ceiling, expansion bolts are required to
fix the camera. For wooden ceiling, self-tapping
screws are required.